Fuller Weighing - Checkweigher Data Application Form

Eliminate the Guesswork with the
Maximum in Control and Reliability

Weighing problems may be caused by environmental influences such as vibration, excess dust, air currents, and non-solid foundations. If any of these factors are present they must be corrected to assure proper performance of the checkweigher.

Company Name	Phone	Fax

Address	City	State	Zip

Person to Contact	Title	E-mail

Power Requirements:
Controller: 110V, 1 Ph, 60 Hz (standard) 220V, 1 Ph, 60 Hz (optional) Other: Conveyor: 220V, 3 Ph, 60 Hz (standard) 460V, 3 Ph, 60 Hz (optional) Other:

Conveyor Speed Specifications:
60 feet per minute 90 feet per minute 120 feet per minute Consult factory for either: Belt speed greater than 120 feet per minute Variable belt speed drive Other:

Conveyor Belt and Size Specifications:
Black polyester belt (standard) USDA white belt (optional) Standard conveyor size (48" L x 24" W x 30" H) Custom conveyor size

Equipment Operation Specifications:
Weight only mode Checkweigh mode

Type Of Packages To Be Weighed:
Check all that apply: Paper Plastic Other: Carton Cardboard Other: Special concerns (reflective, unstable, hot, etc.) Explanation:

Size Of Packages To Be Weighed:

Package No.	1	2	3	4
Length
Width
Height
Weight
Accuracy
Item Rate* / Pkg Spcg**
* Item Rate - the number of containers passing across the conveyor per minute/hour ** Package Spacing - the distance from FRONT of one package to FRONT of the next package (see diagram below).

Package handling limitations to insure proper operation of the checkweigher.

1.) Package spacing must be as follows:
Leading edge to leading edge spacing must be greater than or equal to the length of the scale conveyor (S1). If this spacing is less than specified, a spacing conveyor MUST be supplied by others. This spacing conveyor may be supplied by Cardinal weighing at an additional cost.

2.) Package length must be short enough to allow a minimum of .5 seconds of weigh time between the photoeyes for an accurate weight.
3.) The approach conveyor and the exit conveyor must be moving at the same speed as the scale conveyor and be at the same elevation to insure proper transfer of the products. The standard Cardinal conveyor height is 30" +/- 2" (76 cm +/- 5 cm).